Installing The Driver Software In Windows 2000 - AVM FRITZ!Card USB Installation Instructions Manual

Installing the Driver Software in Windows 2000

2.5 Installing the Driver Software in
12 FRITZ!Card – 2 Installing FRITZ!Card USB v2.1
Windows 2000
Administrator rights are required to install the driver
software in Windows 2000.
Once the FRITZ!Card USB v2.1 is connected to your computer,
the "Found New Hardware Wizard" of Windows 2000 is start-
ed automatically.
Insert the FRITZ!Card CD and follow the instructions on the
screen. Note the following:
1. The "Found New Hardware Wizard" recognizes a new
Plug & Play device to be installed. Click "Next".
2. In the next window, select the option "Search for a suit-
able driver for my device (recommended)" and confirm
your selection with "Next".
3. In the next window, select the option "CD-ROM drives"
and confirm by clicking "Next".
4. The program reports that a driver was found. Click
"Next" to install the driver.
5. In the next dialog Windows may prompt you to install
software not digitally signed by Microsoft. This request
depends on the driver signature options set on your
computer. Answer the question with "Yes". Repeat this
procedure in the next dialog for the AVM NDIS WAN
CAPI Driver.
6. When the Hardware Wizard reports that "Windows has
finished installing the software for this device.", the
"USB" LED on your ISDN-Controller should be lit. If
FRITZ!Card USB v2.1 is connected to a PBX, on some
PBX systems the "D" LEDfor the D channel is also lit up.
7. Conclude the installation by clicking "Finish".
Once the driver software installation has been completed, a
message reports that the FRITZ! communications software
can be installed. For more information, read "Installing the
Communications Software" on page 14.