Setting Up The Sharelink 200 Software; Downloading And Installing The Sharelink 200 Software - Extron electronics ShareLink 200 User Manual

Setting Up the ShareLink 200 Software

Downloading and Installing the ShareLink 200 Software

The ShareLink 200 software can be downloaded from the embedded web pages or from
the Extron website. Follow the instructions below for your preferred download method.
Downloading the software from the embedded Web pages
1.
2.
3.
4.
5.
Downloading the Software from the Extron Website
1.
2.
3.
4.
5.
6.
Ensure that your computer is connected to the ShareLink 200 device, either through
Wi-Fi or through a physical network connection. The computer and the ShareLink 200
must be on the same network.
Launch your internet browser and enter the IP address of the ShareLink 200 into the
browser.
Hyde 116 is: 158.136.28.9
NOTE: The IP address is shown on the standby screen (see
The ShareLink 200 landing page should appear on the browser.
Click Windows or Mac (depending on your operating system) to launch the software
installer on your computer.
Follow the instructions on the web browser to run the the executable ShareLink 200
Software installer file.
Follow the steps on the installation wizard to install the software.
Go to
www.extron.com
1 ).
2 2
Figure 7. Download Page on the Extron Website
Click Software on the left menu ( 2 ).
Scroll down to the alphabetical menu and click the letter S.
Scroll down to the software names and look for ShareLink 200. Click Download in the
ShareLink 200 section.
On the next screen (Download Center), enter the requested information and click the
download button.
When download is complete, open the executable ShareLink 200 Software installer file
and follow the steps on the installation wizard to install the software.
and click the Download tab at the top of the page (figure 7,
1 1
ShareLink 200 • Operation Using a Computer
figure 4, 4 on page 5).
9