Flexible Shaft - Ozito ROTARY TOOL SET Original Instructions Manual

2. CHANGING ACCESSORIES CONT.
Locating a cutting/sanding disc
1 Remove the screw from
the end of the disc holder.
2 Fit the fibre flange either side
of the cutting disc, then insert
the screw.
Note: Do not over-tighten the screw as it could result in damage to the
cutting disc.
Locating a sanding drum
1 Loosen the screw on the top
of the sanding drum holder.
3 Tighten the screw until
the sanding drum sleeve
is secured.
3 Tighten the cutting disc onto
the cutting disc holder.
2 Slide the sanding drum onto
the sanding drum holder.

3. FLEXIBLE SHAFT

1 Remove the shaft collar.
3 Raise the handle end of
the flexible shaft & shake
gently until the inner
flexible shaft protrudes
from the fitting collar.
4 Insert the inner flexible shaft into the collet then tighten the collet
nut.
5 Screw the flexible shaft
fitting collar onto the
rotary tool.
6 Insert the spindle lock key into
the hole on the handle.
8 Tighten collet nut and check all fittings to ensure they are securely
fastened.
2 Loosen the collet nut.
b
a
7 Loosen collet nut then insert
shank of accessory into collet.
b
a