Dräger X-am 5100 Technical Manual page 9

3.1.5 Before entering the workplace
WARNING
!
Before safety-related measurements, check the
calibration and recalibrate if necessary. A bump test
must be carried out in accordance with the national
regulations.
1. Switch on the instrument. The current measured values are
shown in the display.
Observe any warning »

The instrument can be operated normally. If the warning
message does not disappear automatically during
operation, the instrument must be serviced after the end
of use.
The instrument is not ready to measure and requires
maintenance.
2. Check that the gas inlet opening on the instrument is
not covered.
Dräger X-am 5100
« or fault messages » «.
Use
9