Default Settings For San Port Channels - Cisco Nexus 5000 Series Configuration Manual

Default Settings for SAN Port Channels

Example of Verification Commands
The following example shows how to display a summary of SAN port channel information:
switch# show san-port-channel summary
------------------------------------------------------------------------------
Interface
------------------------------------------------------------------------------
san-port-channel 7
san-port-channel 8
san-port-channel 9
The following example shows how to display SAN port channel consistency:
switch# show san-port-channel consistency
Database is consistent
The following example shows how to display details of the used and unused port channel numbers:
switch# show san-port-channel usage
Totally 3 port-channel numbers used
===================================
Used
Unused:
Autocreated SAN port channels are indicated explicitly to help differentiate them from the manually created
SAN port channels. The following example shows how to display an autocreated port channel:
switch# show interface fc2/1
fc2/1 is trunking
Belongs to port-channel 123
...
Default Settings for SAN Port Channels
The table below lists the default settings for SAN port channels.
Table 16: Default SAN Port Channel Parameters
Parameters
Port channels
Create port channel
Default port channel mode
Autocreation
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide
88
Total Ports
: 77 - 79
1 - 76 , 80 - 256
Hardware is Fibre Channel, FCOT is short wave laser
Port WWN is 20:0a:00:0b:5f:3b:fe:80
...
Receive data field Size is 2112
Beacon is turned off
Port-channel auto creation is enabled
Oper Ports
2 0
2 0
2 2
Default
FSPF is enabled by default.
Administratively up.
On.
Disabled.
Configuring SAN Port Channel
First Oper Port
--
--
OL-xxxxx-xx