Configuring Port Tracking
Command or Action
Step 3
switch(config-if)# port-track force-shut
Step 4
switch(config-if)# no port-track force-shut
Displaying Port Tracking Information
The show commands display the current port tracking settings for the switch.
The following example shows how to display tracked port configuration for a specific interface:
switch# show interface fc2/1
fc2/1 is down (Administratively down)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
...
The following example shows how to display tracked port configuration for a SAN port channel:
switch# show interface san-port-channel 1
port-channel 1 is down (No operational members)
...
The following example shows how to display the port track mode:
switch# show interface fc 2/4
fc2/4 is up
...
back up
Default Port Tracking Settings
The following table lists the default settings for port tracking parameters.
OL-xxxxx-xx
Hardware is Fibre Channel, FCOT is short wave laser w/o OFC (SN)
Port WWN is 20:01:00:05:30:00:0d:de
Admin port mode is FX
Port vsan is 1
Receive data field Size is 2112
Beacon is turned off
Port tracked with interface fc2/2 (down)
Port tracked with interface san-port-channel 1 vsan 2 (down)
Hardware is Fibre Channel
Port WWN is 24:01:00:05:30:00:0d:de
Admin port mode is auto, trunk mode is on
Port vsan is 2
Linked to 1 port(s)
Port linked to interface fc2/1
Hardware is Fibre Channel, FCOT is short wave laser
Transmit B2B Credit is 64
Receive B2B Credit is 16
Receive data field Size is 2112
Beacon is turned off
Port track mode is force_shut <-- this port remains shut even if the tracked port is
Purpose
Forcefully shuts down the tracked port.
Removes the port shutdown configuration for the tracked
port.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide
Displaying Port Tracking Information
253