Chapter 8 Reset And Restart Vantage Radius; Resetting Vantage Radius; Procedure To Use The Reset Button - ZyXEL Communications Vantage RADIUS 50 User Manual

RESET and RESTART Vantage RADIUS
8.1

Resetting Vantage RADIUS

If you forget your password or cannot access the web configurator, you will need to reload the factory-
default configuration file or use the RESET button on the side panel of the ZyAIR. Uploading this
configuration file replaces the current configuration file with the factory-default configuration file. This
means that you will lose all configurations that you had previously. The username will be reset to ADMIN
and the password will be reset to 1234.
8.2

Procedure To Use The Reset Button

Make sure the SYS LED is on (not blinking) before you begin this procedure.
1. Press the RESET button for ten seconds or until the SYS LED and PWR LED turns red, and then
release it. If the SYS LED begins to blink, the defaults have been restored and the Vantage
RADIUS restarts. Otherwise, go to step 2.
2. Turn the Vantage RADIUS off (disconnect the device from the power source).
3. While pressing the RESET button, turn the Vantage RADIUS on (connect the device to the power
source).
4. Continue to hold the RESET button. The SYS LED will begin to blink and flicker very quickly
after about 20 seconds. This indicates that the defaults have been restored and Vantage RADIUS is
now restarting.
5. Release the RESET button and wait for the Vantage RADIUS to finish restarting.
RESET and RESTART
This chapter details how to reset and restart your Vantage RADIUS
Vantage RADIUS User's Guide
Chapter 8
8-1