Copy/Sync Button; Reset Button - ZyXEL Communications NSA221 User Manual

Chapter 1 Getting to Know Your NSA
Table 1 LEDs (continued)
LED
LAN
COPY/
SYNC

1.3.1 COPY/SYNC Button

Use the COPY/SYNC button on the front panel to copy or synchronize files
between a connected USB device and the NSA. See
more details on how to configure the copy/sync settings.

1.3.2 RESET Button

Use the RESET button on the rear panel to restore the NSA's default settings.
Figure 3 The RESET Button
Press
• Press the RESET button until you hear one beep (after about two seconds),
then release it. You will hear one more beep after you release the button.
This resets the NSA's IP address and password to the default values.
24
COLOR STATUS DESCRIPTION
Green On The NSA has a successful 10/100 Mbps Ethernet
connection.
Blinking The 100M LAN is sending or receiving packets.
Off The NSA does not have a 10/100 Mbps Ethernet
connection.
Amber On The NSA has a successful 1000 Mbps Ethernet
connection.
Blinking The 1000 M LAN is sending or receiving packets.
Off The NSA does not have a 1000 Mbps Ethernet
connection.
Green On A USB device is connected to the NSA.
Blinking The NSA is copying or synchronizing files to or from the
USB device.
Red On Copying or synchronizing files to or from the USB device
failed.
Off No USB device is connected.
1 Beep
Release to Reset
IP Address
Password
Section 9.10 on page 204
2 Beeps
5 more seconds
Release to
Clear All Settings
NSA221 User's Guide
for