High Beam Button; Heated Grips (If Fitted) - Triumph Street Twin Owner's Handbook Manual

High Beam Button

When the high beam button is pressed
the high beam will be switched on. Each
press of the button will swap between
dip and high beam.
Note:
• If daytime running lights are fitted
to the motorcycle, the high beam
button has additional functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
Note:
• A lighting on/off switch is not fitted
to this model. The position light,
rear light and licence plate light all
function automatically when the
ignition is turned to the ON position.
• The headlight will function when
the ignition switch is turned to the
ON position. The headlight will go
off while pressing
button until the engine starts.

Heated Grips (if fitted)

The heated grips work when the ignition
is
recommended that they are only used
when the engine is running to avoid
draining the battery.
There are two heat levels; low or high.
cjpj
1.
The heated grips button is located on
the left hand grip.
Press the heated grip button to show
the current status of the heated grips
in the display screen. This is shown for
three seconds.
the starter
Press the heated grip button whilst the
status is showing to select one of the
three different heat levels; OFF, Lo (low)
or HI (high).
For maximum benefit in cold conditions,
use the heated grips on the HI level
initially
warmed up, change to Lo.
To switch off the heated grips, press
and release the button until OFF is
shown in the display screen. The heated
grips are also switched off when the
ignition is switched off.
General Information
switched on.
1
Heated grips button
and when
However, it is
the grips have
51