Stop Position; Run Position; Start Position; Mode Button (If Fitted) - Triumph Street Twin Owner's Handbook Manual

STOP Position

The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
Note:
• Although the engine stop switch
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged
battery. Ordinarily, only the ignition
switch should be used to stop the
engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical components
discharge the battery.

RUN Position

In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.

START Position

The START position operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar and the start/stop switch in
the START position.
Note:
•

MODE Button (if fitted)

The
response adjustment. Press and release
the MODE button to select one of the
different rider modes available (see
page 39 for more information).

Hazard Warning Lights

and will
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
General Information
Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down
and a gear is engaged.
MODE button allows throttle
49