Table of Contents
Advertisement
6 Software
6.1 Requirements
PC with Windows 2000/XP/Vista/Win7, 64 MB RAM minimal memory
about 10 M
free memory on the hard disc for program files
B
6.2 Software Installation
Make sure any sensor or sensors are turned on before running the program. The Startup Wizard runs
the first time you use the program.
Software Start
1.
The Startup Wizard runs the first time you use the program. After the first saving your settings,
the program starts at the Main screen.
2.
The <Open an Existing Configuration> button opens a dialog for selecting an already existing
configuration file. Clicking on the <Create a New Configuration> button will call up the Startup
Wizard.
3.
Choose the appropriate communications COM port. Note that only available ports are active.
Select the <ASCII protocol> from the drop-down list.
4.
Click the <Continue> button and follow the instructions!
After communication with the devices (real or simulated) is established, a screen showing, how many
devices are attached as well as their identification numbers and types of devices. Check here to make
sure all installed devices are connected properly
Note:
If you notice that not all devices were found, click on the Back button to return to the previous
screen, then go check your sensor connections. After checking, click on the <Continue> button
so the software rescans for connected devices.
XR
Figure 36: Selection of Communication Protocol
Rev. B2 Feb 2017
Software
Select
<ASCII Protocol>
43
Advertisement
Table of Contents
