Table of Contents
Advertisement
6 Software
Raytek DataTemp Multidrop software allows the configuration and
monitoring of CM sensor operating parameters, such as:
Emissivity
Transmissivity
Averaging
Peak hold
Valley hold
Temperature scale of analog output
Alarm temperature value
1 point field calibration offset
Alarm output
Refer to DataTemp software online help for more detail.
Notes for CM sensors:
1.
Use the Temperature unit in Degree C for field calibration, if in
Degree F, there is no effect.
2.
CM shares the alarm line with the RS232 TxD and the alarm function
will be temporarily turned off and changed to RS232 mode when
connecting to the DataTemp software. After re-powering the sensor
without connecting to the DataTemp software, the alarm mode will
function normally.
CM
Rev. B 06/2011
Software
22
Advertisement
Table of Contents
Need help?
Do you have a question about the RAYCMLTJM and is the answer not in the manual?
Questions and answers