RayTek XR Operating Instructions Manual page 20

Operation
20
Put the seal-cap (2) on the cable. Screw the end nut (8) and seal-
cap (2) together, not too tight. Keep the cable revolve freely.
Connect the wires to terminal connector (1).
Plug the connector (1) in unit.
Hold the cable tightly. Screw the seal-cap (2) to the unit. Keep the
cable don't revolve with the seal-cap (2).
Screw up the seal cap (2) by spanner or by hand.
Screw up the end nut (8) by spanner or by hand.
Rev. B2 Feb 2017
XR