Table of Contents
Advertisement
O
i
M
D
1
U
s
e
r
'
s
G
u
i
d
e
O
i
M
D
1
U
s
e
r
'
s
G
u
i
d
e
4.2. Quick Installation Guide
4.2.1. Connect PC and OiMD1 to network.
1. Prepare a PC to run programs for the installation and video connection
Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to
(PC is needed to assign IP address to OiMD1)
2. In the case of using PoE, connect the PC and
your LAN Switch does not support standard PoE, connect
your LAN Switch does not support standard PoE, connect OiMD1 as shown in dotted line in Figure 4
The DC power is applied through DC adapter.
The DC power is applied through DC adapter.
4.2.2. Install Speco-NVR and set IP parameters on
Speco-NVR is a multi-channel VMS program for the IP camera. Install Speco
connect to these products. It is needed to assign connection information to Speco
connect to these products. It is needed to assign connection information to Speco-NVR program before
connection. Insert the CD provided with product into the PC and install Speco
connection. Insert the CD provided with product into the PC and install Speco-NVR.
to network.
, connect the PC and OiMD1 to the network using one of the following ways. If
LAN switch
LAN switch with
standard POE
(802.3af)
Figure 4-1. Power and network connection
Figure 4
and set IP parameters on OiMD1
channel VMS program for the IP camera. Install Speco-NVR on remote PC to
Figure 4-2. Speco-NVR
to the network using one of the following ways. If
as shown in dotted line in Figure 4-1.
DC adaptor
NVR on remote PC to
ONSIP Installer
NVR program before
Admin Page Button
Admin Page Button
Advertisement
Table of Contents
