Table of Contents
Advertisement
DEVICENET PROTOCOL
NOTE:
NOTE
3-40
5.
Enter 0 in the New Device Settings: Node Address box.
6.
Click Apply and exit the dialog.
The network must not be active when performing node commissioning on the 1747-SDN
module. Make sure the processor is in Program mode. (Note that this applies only to the
1747-SDN module. You may commission other devices with the processor in Run mode.)
Setting up the scan list for the scanner
1.
After setting node address of the scanner click on Single Browse from the network
menu. The 1747 SDN module should appear with the new node ID.
2.
Double-click the 1747-SDN module icon. The following dialog will appear:
3.
Click the Module tab. You will receive the following prompt:
MM200 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE
CHAPTER 3: FIELDBUS INTERFACE
Hide quick links:
Advertisement
Table of Contents
