Table of Contents
Advertisement
CHAPTER 3: FIELDBUS INTERFACE
NOTE:
NOTE
MM200 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE
5.
Configure the driver using the settings above as a guide, and click on OK. The software
takes a few seconds to configure the driver. When it is complete, the following prompt
appears:
This dialog will only appear if there is at least one active node on the DeviceNet network.
So ensure that the network power is on and that the MM200 relay and the scanner are on
the DeviceNet network.
6.
Select the default driver name, 1770-KFD-1, and click OK. Close the RSLinx software.
Configuring the network and going online
The next step is to configure the network with RSNetWorx for DeviceNet software using the
driver that was just configured.
Follow these steps to set up an online connection to the DeviceNet network, using the
1770-KFD driver:
1.
Start RSNetWorx for DeviceNet software. The following dialog appears:
DEVICENET PROTOCOL
3-33
Hide quick links:
Advertisement
Table of Contents
