Delay - Reer MOSAIC Master M1 Installation And Use Manual

DELAY operator applies a delay to a signal by
setting the output to 1 (TRUE) after the set
time, against a change in the level of the
input signal.
Parameters
Time: The delay can be set to between
Rising edge: If selected, the delay starts on the input signal's rising edge at the end of
which the output changes to 1 (TRUE) if the input is 1 (TRUE) where it remains for as long
as the input stays at 1 (TRUE).
In
Out
If not selected the logic is inverted, the output is set to 1 (TRUE) on the input signal's
rising edge, the delay starts on the input signal's falling edge, at the end of the set time
the output changes to 0 (FALSE) if the input is 0 (FALSE) otherwise it remains 1 TRUE.
In
Out
Retriggerable: If selected the time is reset each time the input status changes.
122
T
T T
MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
T
T T
8540780 • 30/03/2016 • Rev.26