Engine And Transmssion Install - Linhai LH400CUV-2 Service Manual

CHAPTER 6 TRANSMISSION

6.7 ENGINE AND TRANSMSSION INSTALL

Transmission
1. Position transmission in frame, Align rear drive
shaft and slide shaft into the yoke.
2. Install all brackets, loosely install new fasteners.
3. Tighten fasteners in "right -left– rear" order.
NOTE: While tightening, it is important to turn the
rear drive shaft by hand to check the position of
transmission. If the rear drive axle can not turn freely,
it is necessary to loose (but not remove) the
fasteners to re-position
tightening the fasteners in different order.
Transmission Mounting Bolts Torque: 25 ft. lbs. (35
Nm ).
4. Drive in a new roll pin.
5. Position Engine in frame, Install all brackets,
loosely install new fasteners, but not tighten
fasteners.
6. Make sure those spacers are in correct position.
7. Link engine and transmission together with
engine mount jig. (center distance of engine
shaft and transmission main shaft is 252 mm
and distance of side surface and shaft shoulder
62.5 mm)
8. Tighten engine mounting fasteners in top-to
bottom order.
9. Remove jig.
10. Install both drive and driven clutches and outer CVT cover.
Engine Mounting Bolts Torque: 25 ft. lbs. (35 Nm).
the transmission by
CHAPTER 6
CUV SERVICE MANUAL 07.0
TRANSMISSION PAGE. 6- 7