Rear Hub Exploded View - Linhai LH400CUV-2 Service Manual

CHAPTER 5 FINAL DRIVE
joint cavity behind the bearing assembly with
additional molybdenum disulfide grease.
12. Pack each boot with the following amounts of
molybdenum disulfide grease:
a. Inboard boot:35-55grams(1.2-1.9oz.).
b. Outboard boot:30-50grams(1.1-1.8oz.).
13. Move the inboard boot onto the inner CV joint.
14.Move the inboard joint on the drive axle.
NOTE: Position the new boot bands with their tabs
facing toward the rear of the vehicle .
14. Move the small boot band onto the boot. Bend
down the tab on the boot band and secure the
tab with the locking clips and tap them with a
plastic hammer. Make sure they are locked in
place.
15. Install the large boot bands onto each boot.
CAUTION: It is critical to avoid undue stress on the
rubber boots after the drive axle is installed and the
vehicle is run. Don't twist the boot, and always set
the both ends in designed position.
16. Secure all large boot bands. Bend down the tab
on the boot band and secure the tab with the
locking clip and tap them with a plastic hammer.
Make sure they are locked in place.
17. If removed, install the stopper ring and make sure
it is seated correctly in the drive axle groove.
18. Apply molybdenum disulfide grease to the end
splines.

5.10 REAR HUB EXPLODED VIEW

CUV SERVICE MANUAL 09.0
CHAPTER 5 FINAL DRIVE. 5- 10