Linhai LH400CUV-2 Service Manual page 71

CHAPTER 3 ENGINE
ATV SERVICE MANUAL 2005/ version number 0501
NOTE:
Temporarily tighten the nut while attaching the
clutch spring holder  and clutch spring holder
arm  and compress the spring.
CAUTION:
Use the spacer  (30mm, thickness: 2-3mm).
6. Install:
V-belt 
Clutch assembly 
NOTE:
Install the V-bet with clutch assembly to the
primary sheave side.
CAUTION:
Never smear grease to the V-belt, secondary
sheave and clutch.
7. Install:
Nut  (clutch carrier)
NOTE:
Tighten the nut (clutch carrier), using the locknut
wrench  while holding the clutch carrier with
the rotor holder 
8. Install:
Clutch housing 
Nut (clutch housing) 
NOTE:
Tighten the nut (clutch housing),using the
sheave holder ).
9. Set:
CHAPTER 3 ENGINE PAGE. 3- 45