Advertisement
Ethernet
For convenience, the JunoX comes with DHCP on. This enables the switcher to be
connected to a network without knowing available IP addresses. If your network does not allow
dynamic IP addresses or if you are using the switcher with a TCP/IP control system, this feature may
be turned off and the IP address set using front panel.
Note: Press and hold the input button on the front panel to switch between static and DHCP IP address.
Two button flashes means the unit is in static mode and four button flashes means the unit is DHCP.
Static IP configuration will be: 192.168.1.254 - 255.255.255.0
Connection Diagram
3
Video
J
X
UNO
Video
Audio
Troubleshooting
1. How do I update my unit?
Firmware and instructions can be found and downloaded from the firmware tab at
http://www.atlona.com/product/AT-JUNO-451
2. What types of control can be used with my unit?
The Juno can be controlled using TCP/IP, RS-232, webGUI, or AMS
3. Why is my unit not auto switching?
Auto switching comes disabled. Auto switching can be enabled through AMS, webGUI, or
RS-232 - TCP/IP using the 'AutoSW on' command.
Note: All RS-232 and TCP/IP commands are followed by a carriage return
atlona.com
1
TM
1
2
3
HDMI IN
Video
INPUT
POWER
2
3
4
4
HDMI OUT
OPTICAL
Audio
4
Game Console
INPUT
FW
Video
AT-JUNO-451
RX TX
S
RS-232
IR IN
LAN
DC 5V
Audio
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Advertisement
