Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Disconnect the power connector cable (1) from the system board.
2.
Remove the three Phillips PM2.5×4.1 screws (2) that secure the power connector cable bracket to
the keyboard/top cover.
3.
Remove the power connector cable bracket (3).
The power connector cable bracket is not spared separately.
4.
Remove the power connector cable (4).
Reverse this procedure to install the power connector cable.
Bottom cover on page
27).
Spare part number
808155-017
Battery on page
29).
Component replacement procedures
35
Advertisement
Table of Contents
