Table of Contents
Advertisement
Solid-state drive
Description
1-TB, M.2 2280, PCIE, 3×4 SS NVMe solid-state drive supporting TLC CN
512-GB, M.2 2280, PCIE, 3×4 SS NVMe solid-state drive supporting TLC CN
256-GB, M.2 2280, PCIE, 3×4 SS NVMe solid-state drive supporting TLC CN
128-GB, M.2 2280, SATA-3 solid-state drive
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×3.2 screw (1) that secures the solid-state drive to the computer. (The solid-
state drive tilts up.)
2.
Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Bottom cover on page
27).
Spare part number
865697-003
847110-011
847109-013
827560-029
Battery on page
29).
Component replacement procedures
33
Advertisement
Table of Contents
