Table of Contents
Advertisement
Display assembly
NOTE:
The display assembly is spared at the subcomponent level only. For display assembly spare part
information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Remove the three Phillips PM2.5×4.1 screws (1) that secure the power connector cable bracket to
the keyboard/top cover.
2.
Remove the power connector cable bracket (2).
The power connector cable bracket is not spared separately.
3.
Remove the two Phillips PM2.5×4.1 screws (3) that secure the USB bracket to the keyboard/top cover.
4.
Remove the USB bracket (4).
The USB bracket is not spared separately.
5.
Release the zero insertion force (ZIF) connector (1) to which the display panel cable is connected,
and then disconnect the display panel cable from the system board.
6.
Disconnect the webcam/microphone module cable (2) from the system board.
36
Chapter 5 Removal and replacement procedures
Bottom cover on page
27).
Battery on page
29).
Advertisement
Table of Contents
