Table of Contents
Advertisement
3.
Remove the two Torx5 M2.0×3.3 screws (1) and the two Torx5 M2.0×6.3 screws (2) that secure
the bottom cover to the computer.
4.
Insert a case utility tool (1) or similar plastic, flat-edged tool between the bottom cover
and the computer near the display hinge area.
5.
Release the rear edge of the bottom cover (2) and swing it up and forward until it releases.
6.
Remove the bottom cover (3).
Reverse this procedure to install the bottom cover.
28
Chapter 5 Removal and replacement procedures
Advertisement
Table of Contents
