Ducati Monster 1200 Owner's Manual page 86

Note
When the LAP function is active, the FLASH
button takes on the dual function of high beam
"FLASH" and GPS finish line control and storage for
the LAP timer (new lap start indication).
Note
The TRIP FUEL function always has top priority
over the LAP function: in case of activation of the
TRIP FUEL function with active LAP function, the LAP
timer view is automatically removed and TRIP FUEL
information is displayed instead.
LAP recording
If the LAP function is active, the lap time can be
recorded for a total of 30 consecutive laps.
Operation:
- to allow the GPS to automatically identify the
"Start/Stop" at every lap, the finish line
coordinates must be saved by pressing the
FLASH (3) button upon first crossing of the finish
line. The lap timer starts with a tenth-of-a-second
resolution (0'00''00);
84
- with every successive crossing of the finish line
the number and time for the lap just completed
is displayed for 5 seconds and with the tenth-of-
a-second resolution;
- after these 5 seconds, the instrument panel goes
back to lap timer page referred to the new current
lap.
- on the 30th lap, when the FLASH button (3) is
pressed, and every time it is pressed, current lap
is stored and the message FULL is displayed to
indicate that available storage space is full.
If the time is never stopped, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from zero and will keep
running until the lap is stopped or the recording
function is disabled.
During every lap, the following data are stored:
- no. 30 lap times (time between consecutive start
and stop);
- no. 30 values for max. RPM (maximum RPM
value reached in every lap);
- no. 30 values for max. speed (maximum speed
value reached in every lap).