Installing The Tail Wheel - Phoenix Model TIGER MOTH Instruction Manuals

Instruction Manual
Crimp
Cable
Cable end
5. Thread the metal connector to the link ball.
6. Center the rudder servo using the radio and
install the servo arm. Attach the metal clevis to
the rudder servo arm.
7. Slide a crimp onto the cable, then pass the cable
through the threaded cable end. Pass the cable
back into the crimp and use crimping pliers to
secure the crimp to the cable.
8. Thread the metal connector to the metal clevis.
9. Attach the clevis to the rudder servo. There
should be light tension on each of the wires
when installed properly.
Note: Remember use thread locking compound
to secure.
Aluminum ball
Plastic ball link
Metal connector
40
41
42

INSTALLING THE TAIL WHEEL

1. The tail wheel set.
2. Remove the covering.
3. Secure the plate to the rudder.
9
TIGER MOTH
M3 Clevis
43
44
45
46