Speakers - HP ENVY *360 15M Maintenance And Service Manual

2. Remove the SD card board (2).
Reverse this procedure to install the SD card board.

Speakers

Description
Speakers (includes cables and four rubber isolators)
Before removing the speakers, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the system board (see
Remove the speakers:
1. Release the speaker cable from the retention clips (1) and routing channel built into the keyboard/
top cover.
2. Remove the display panel cable from the retention clips (2) and routing channel built into
the left speaker.
3. Remove the four Phillips PM2.0×6.3 broad head shoulder screws (3) that secure the speakers to
the keyboard/top cover.
Bottom cover on page
Battery on page 32).
System board on page
30).
41).
Component replacement procedures
Spare part number
924343-001
51