Table of Contents
Advertisement
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×2.4 broad head screw (1) that secures the solid-state drive to
the system board.
2.
Remove the solid-state drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
Memory module
NOTE:
Primary and expansion memory is installed in a side-by-side configuration on the system board. If
only one memory module is installed, it must be installed in the socket labeled 1.
Description
8-MB, SODIMM, DDR4-2400, 1.2-V
4-MB, SODIMM, DDR4-2400, 1.2-V
Update BIOS before adding memory modules
Before adding new memory, make sure you update the computer to the latest BIOS.
CAUTION:
Failure to update the computer to the latest BIOS prior to installing new memory may result in
various system problems.
To update BIOS:
1.
Navigate to www.hp.com.
2.
Click Support & Drivers, and then click Drivers & Software.
3.
In the Enter a product name/number box, type the computer model information, and then click Search.
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
30).
32).
Component replacement procedures
Spare part number
862398-855
862397-855
35
Hide quick links:
Advertisement
Table of Contents
