Speakers - HP ZHAN A 14 inch G6 Maintenance And Service Manual

To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.

Speakers

To remove the speakers, use this procedure and illustration.
Table 5-6 Speaker description and part number
Description
Speaker Kit
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the speakers:
1. Lift the Mylar that covers the connectors, and then disconnect the two speaker cables (1) from the
system board.
2. Remove the four Phillips M1.6 × 3.0 screws (2) that secure the speakers.
3. Remove the speakers from the computer (3).
NOTE:
in the speakers.
To install the speakers, reverse this procedure.
Bottom cover on page
When installing the speakers, be sure that the rubber grommets (4) are correctly installed
Preparation for disassembly on page
29).
Battery on page
Spare part number
N60152-001
29).
30).
Speakers 37