HP ENVY *360 15M Maintenance And Service Manual page 51

When replacing the system board, be sure to remove the following components from the defective system
board and install them on the replacement system board:
● Memory module (see
● Fan/heat sink assembly (see
● WLAN module (see
Remove the system board:
1. Disconnect the following cables from the system board:
(1) Power connector cable
(2) WLAN antenna cables
NOTE: The #1/white WLAN antenna cable connects to the WLAN module "#1/Main" terminal. The #2/
black WLAN antenna cable connects to the WLAN module "#2/Aux" terminal.
(3) Webcam/microphone module ZIF connector cable
(4) Display panel ZIF connector cable
(5) Speaker cable
(6) SD card board ZIF connector cable
(7) Hard drive ZIF connector cable
(8) Backlight ZIF connector cable
(9) Keyboard ZIF connector cable
(10) ClickPad ZIF connector cable
Memory module on page
Fan/heat sink assembly on page
WLAN module on page 49)
35)
45)
Component replacement procedures 43