Display Assembly - HP ENVY *360 15M Maintenance And Service Manual

Display assembly

NOTE: The display assembly is spared at the subcomponent level. For display assembly spare part
information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. System board (see
c. Speakers (see
Remove the display assembly:
1. Remove the six Phillips PM2.5×4.3 screws that secure the display assembly to the keyboard/top cover.
2. Release the WLAN antenna cables (1) and the webcam/microphone module cable from the retention clip
built into the keyboard/top cover.
3. Release the display panel cable (2) from the retention clip built into the keyboard/top cover.
4. Swing the display hinges (3) up and back.
5. Swing the keyboard/top cover (4) up and back until it separates from the display assembly.
Bottom cover on page
Battery on page 32)
System board on page
Speakers on page 51)
30), and then remove the following components:
41)
Component replacement procedures 53