Table of Contents
Advertisement
Installing the memory module
1.
Read through the instructions on page 4 of this chapter.
2.
Holding the memory module by its edges, align the module so its edge engages in the guide
rail at the back of the electronics bay.
C C A A U U T T I I O O N N
The memory module is held in place by the 242-pin connector on the baseboard, the guide rail at
the back of the electronics bay, and a plastic guide at the front of the electronics bay. You must
support the module until it is fully seated in the connector.
3.
Push the memory module toward the baseboard until it fully engages its connector.
M a i n b o a r d
FT5000 HANDBOOK
5/13
Advertisement
Table of Contents
