Table of Contents
Advertisement
4.
Grasp the small outer bar with your right hand so that your thumb is on the safety latch of
the small outer bar.
5.
Press and hold the safety latch down, and at the same time, grasp the large outer bar with
your left hand.
6.
Pull the small bar out of the centre bar; this takes a little force to separate them. Set the small
bar aside to attach to the chassis in a later step.
7.
Orient the centre bar and large outer bar assembly so that the centre bar is facing up.
8.
Grasp the centre bar with your right hand and the large outer bar with your left hand so that
your left-hand thumb is on the safety latch of the centre bar.
9.
Press the safety latch, and slide the bars together. Set the centre bar and large outer bar
assembly aside to attach to the equipment rack in a later step.
10. Prepare the other slide assembly by repeating steps 2–9 above.
Prepare the server
Before you can install the FT5000 in the 19-inch equipment rack, you must install a bezel, handles
and the small bars of the slide assemblies onto the sides of the server.
Attaching the bezel frame and door
To be installed in a rack, the server needs a bezel frame with rectangular cutouts where the chassis
handles fit.
1.
Attach the bezel frame by inserting the tabs at the corner of the frame into their
corresponding rectangular slots on the chassis.
2.
Attach the bezel door: with the door all the way open (down, as the server lay as it would
when inserted in a rack), align the tabs on the door with their corresponding hinge loops on
the chassis; slide the door to the right to engage the tabs in the loops.
Attach the chassis handles
Before you can attach the chassis handles, the server must be on its side, in the horizontal position
in which you will slide it into the rack. If the server is not already in the proper position, you must
move it. See step one, below.
1.
If the server is not already in the proper position, then face the front of the server and, with
the help of a mechanical assist unit, carefully tip it onto its left side, (the front-panel LEDs
should now be at the top left and the hard drive bays at the bottom right of the front panel).
2.
Orient each handle so the two screw holes on the long edge of each handle align with the
threaded holes in the chassis. Because the bezel frame's cutouts act as guides, the handles can
be installed in only one way.
3.
Use four screws from the kit to attach the handles to the chassis.
The bezel frame has rectangular cutouts on its edges where the chassis handles fit; you
should be able to see two threaded holes in that cut-out space where the handles attach to
the chassis.
R a c k m o u n t i n g t h e F T 5 0 0 0
FT5000 HANDBOOK
A/5
Advertisement
Table of Contents
