Mitsubishi Electric FT5000 Handbook page 24

Ft series
Table of Contents

Advertisement

W o r k i n g i n s i d e t h e s y s t e m
5.
Record the drive model and serial numbers in your equipment log at the rear of the
handbook.
6.
Set any jumpers or switches on the drive according to the drive manufacturer's instructions.
7.
Using two screws of the appropriate size and length (not supplied), attach each plastic slide
rail with its metal grounding plate to the drive.
C
8.
Position the drive so the plastic slide rails engage in the bay guide rails. Push the drive into
the bay until the slide rails lock in place.
9.
Connect a power cable to the drive. The connectors are keyed and can be inserted in only one
way.
10. Connect a signal cable to the drive. The connectors are keyed and can be inserted in only one
way.
11. Close the front bezel.
2/6
FT5000 HANDBOOK
A. Tape drive or other removable media device
B. Tab on slide rail
C. Screws (4)
D. Slide rails (2)
SCSI drive: Attach connectors on the cable to the SCSI device or devices you are
installing.
IDE drive: The baseboard has one IDE connector.
D
A
B

Advertisement

Table of Contents
loading

Table of Contents