Table of Contents
Advertisement
C o n f i g u r a t i o n a n d s o f t w a r e u t i l i t i e s
N N O O T T E E
If you run the SSU from nonwritable media, these preferences will be lost when you exit the SSU.
Launching a task
It is possible to have many tasks open at the same time, although some tasks might require
complete control to avoid possible conflicts. The tasks achieve complete control by commanding
the centre of operation until you close the task window.
To launch a task:
In the SSU Main window, double-click on the task name under Available Tasks to display
the main window for that task.
OR
Highlight the task name, and click <OK>.
OR
Use the tab and arrow keys to highlight the desired button, and press the spacebar or
<Enter>.
Resource configuration add-in (RCA) window
The RCA provides three major functions:
Creates representations of devices that cannot be discovered by the system (ISA boards)
Modifies the contents of the system by adding and removing devices
Modifies the resources used by devices
You can use the RCA window to define or add an ISA board by clicking on the appropriate
button. To remove an ISA board, highlight the board in the Devices section of the screen before
clicking on the button. You can add only as many ISA boards as ISA slots available.
1.
From the SSU main window, launch the RCA by selecting the 'Resources' task under the
RCA heading in the task box.
2.
When the RCA window appears, it displays messages similar to the following:
3.
To configure a device, click on it or select its name in the Devices section of the RCA
window and press the spacebar or <Enter>.
4.
You can close the RCA window and return to the AF by clicking on the Close button. Any
changes made will be kept in memory for use by the RCA when it is rerun.
5.
Save all changes by clicking <Save>. Saving writes your current configuration to nonvolatile
storage where it will be available to the system after every reboot.
6.
Closing the window by clicking on the system menu (the dash in the upper-left corner)
discards all changes.
7/16
FT5000 HANDBOOK
Baseboard:
System Board
PCI Card: Bus 00 dev 00 -– Host Processor Bridge
PCI Card: Bus 00 dev 0D –- Multifunction Controller
PCI Card: Bus 00 dev 0F –- Ethernet Controller
PCI Card: Bus 00 dev 12 –- Multifunction Controller
PCI Card: Bus 00 dev 14 –- VGA Controller
Advertisement
Table of Contents
