Programming Options - DSC 3G2075 Installation Manual

Hspa/3g wireless alarm communicator ethernet/internet and hspa/3g dual-path alarm communicator

Table of Contents

3G Alarm Communicator Installation Manual

NOTE: If no value is programmed and DHCP is used, the DHCP Server will configure the address. If an address is programmed and

DHCP is used, the address that you program will be used instead of the DHCP address.

[008] DNS Server IP 2



Programming this Section is not permitted on a UL/ULC listed system.

Default (000.000.000.000)

Enter the IP address for DNS Server 2. Format is 4 fields, each field is a 3 digit decimal. Valid range: 000-255.

NOTE: If no value is programmed and DHCP is used, the DHCP Server will assign this value. If an address is programmed and DHCP

is used, the address that you program will be used instead of the DHCP address.

ROGRAMMING

PTIONS

[010] System Toggle Option

Default (Disable)

[1] This bit is used to enable/disable two way audio over 3G.

[011] Installer Code

Default (CAFE)

Program your installer code for this Communicator module. The installer code will be required when programming the Communicator

module. Valid range: 0000 - FFFF.

[012] DLS Incoming Port

Default (0BF6/3062)

The DLS Incoming Local Port (listening port) is the port DLS IV will use when connecting to the Communicator. If a router or gateway

is used, it must be programmed with a Transmission Control Protocol (TCP) port forward for this port to the Communicator module IP

address. Valid range: 0000 - FFFF.

[013] DLS Outgoing Port

Default (0BFA/3066)

The DLS Outgoing Port is used for outgoing session to DLS IV after an SMS request has been sent to the Communicator. Use this Sec-

tion to set the value of the local outgoing port. The value must be changed if the Communicator is located behind a firewall and must be

assigned a particular port number, as determined by your network administrator. In most cases, changing the default value or configur-

ing your firewall with this port is not required.

Valid range: 0000-FFFF.

NOTE: If Section [006] Toggle Option [7] is ON. DLS will use the Primary path for session. If Section [006] Toggle Option [7] is OFF

DLS will use the Ethernet path, if available.

[020] Time Zone

Default (00)

Use Column 2 (Offset Hours) to find your local Time Zone. Record the two digit HEX value from Column 1 (HEX Value) on the same

row. Program this HEX value for your Time Zone. Valid range is 00 - FF.

Table 7: World Wide Time Zones

HEX

Offset

Std

Value

Hours

Abbrev

-12

BIT

NUT

-11

SST

HAST

THAT

-10

TKT

CKT

-9.5

MIT

AKST

-9

GIT

Location

Baker Island Time

Niue Time

Somoa Standard Time

Hawaii-Aleutian Standard Time

Tahiti Time

Tokelau Time

Cook Island Time

Marquesas Island Time

Alaska Standard Time

Gambier Island Time

HEX

Offset

Std

Value

Hours

Abbrev

5.5

IST

5.75

NPT

XJT

EKST

LKT

VOST

OMSK

NOVT

BTT

BIOT