Table of Contents
Advertisement
232
If and when
– Raise the bonnet.
– Move the loop
in the direction of the arrow and remove the
1
⇒ F ig.
cover
148.
⇒ F ig. 149
– Remove connector
– Remove the bulb by pulling it out and fitting the new one.
– Installation involves the above steps in reverse sequence.
– Fit the cover and close the strap. Make sure that the gasket sits
well on the casing cover during the operation.
– Check whether the new bulb is working.
Main beam headlights
by pulling outward.
2
Fig. 150 Main beam
headlights
– Raise the bonnet.
– Move the loop
in the direction of the arrow and remove the
1
⇒ F ig.
cover
150.
⇒ F ig. 151
– Remove connector
2
– Extract the bulb and fit the replacement so that it sits correctly
into the cut-out on the reflector.
– Installation involves the above steps in reverse sequence.
– Fit the cover and close the strap. Make sure that the gasket sits
well on the casing cover during the operation.
– Check whether the new bulb is working.
Fig. 151 Main beam
headlights
by pulling outward.
Advertisement
Table of Contents
