322 4 •
MODULE REMOV AL AND
-
• INST ALLATION PROCEDURES
4-1
CAM TANK MODULE
1. Turn function switch to "MIC" position.
2. Remove transformer module.
Fig. #7
3. Remove motor belt, main drive belt. To remove main drive belt, it is easier with the
function switch at "STOP" position.
4. Unhook the cable from the still picture clutch by removing the small screw in the STILL-
RUN control Arm.
5. Unscrew the 2 screws supporting the cam tank.
6. Remove cam tank slowly and carefully. Claw should not touch the main casting or any
other metal parts.
7. Re-installation can be done by reversing the above procedure. Checking the adjustment of
claw and No. 2 sprocket teeth timing is necessary and critical. See section 5-1. Also check
loop setter timing adjustment, See section 6-3.
4-2
AMPLI Fl ER MODULE
1. Remove flywheel.
2. Unplug the rear cover speaker cord.
3. (for ESL-2, SSL-2 models only) Unscrew the shoulder screw hooking up the OPT/MAG
switch lever, and remove the lever.
4. Unplug 5 pin sound terminal connector.
5. Remove the three transformer mounting screws and the fuse holder.
6. Unplug MT 9 Pin socket.
7. Amplifier is hooked by the two screws. Push in on the amplifier's chassis, allowing the
edge of the chassis to release from under the two screws mounted in the bottom of the
casting. Sometimes a slight pry with a flat blade screw driver may be necessary to remove
a stuborn amplifier. Slide the amplifier out.
Fig. #8
Fig. #9
- 25 -