Sprocket Shoe; 6-5: Rewind System A. Description - Eiki ESL SERIES Service Manual

(1) Set the function switch to "MIC" and slightly loosen the 4mm nut as shown in
Fig. Fig. #89.
(2) Insert the El Kl tension roller gauge.(185-01211) (F[g. #90, #91)
(3) Push the tension roller down against the gauge. {18.8mm)
(4) Holding the tension roller, tighten the 4mm nut.
(5) Remove the gauge and check the rollers position in "STOP" "MIC" and "REWIND".
f. The tension spring may be adjusted by slightly stretching if necessary to minimize wow
and flutter. A weak spring should be replaced. A properly adjusted tension roller should
ride in the middle of it's travel.
8. #2 Sprocket Shoe Adjustment
The #2 Sprocket Shoe Assembly closes around the #2 sprocket when the projector is
in the "MIC" or No. 2 or 3 position. (Fig.#60)
With the rotary switch at "STOP" position, loosen the two set screws on the No. 2 sprocket
shoe interlocking arm bracket.
Turn the rotary switch to "MIC" position, and push down the No. 2 sprocket shoe bracket
completely against the No. 2 sprocket. Secure the two set screws. {Fig, #92)
Note : No end play is allowed for #2 sprocket shaft. (Fig. #92)
6-5 REWIND SYSTEM
- 64 -