Adjustment - Eiki ESL SERIES Service Manual

2. Adjustment:
(a) In the run position the spacing between the clutch lever and the inside flange of the
shutter hub should be approximately 0.2mm (see "Fig. #32). Adjust the set screw
(322-11331)
Fig. #32
for correct spacing and secure the jam nuts. The above adjustment is critical for proper
clutch action. If the space is too large, the clutch will not release in still and if the
space is smaller, the clutch will slip in run.
(b) The correct position of the heat filter is determined by the cable tension.
In the run position the cable is tight, holding the heat filter above the aperture open-
ing. Adjust the white duracon wire guide position to insure that the heat filter is
clear of the optical path (see Fig. # 33)
- 36 -