Connecting To Hdbaset Module - Eiki EK-830 Series Owner's Manual

• The illustration
is for reference
only, actual layout
may vary.
Basic Operations

Connecting to HDBaseT Module

HDBaseT is a connectivity standard for whole-house and
commercial distribution of uncompressed HD multimedia content.
After installing the HDBaseT module to the projector and using
the HDBaseT switching matrix (commercially available), you
may connect multiple sources to your projector with HDBaseT
connection.
VGA IN
Use a shielded LAN cable up to 100 meters in length rated at
™
CAT5e or better.
The maximum transmission distance is 100 m. However, it may be
™
shorter under some circumstances.
Avoid using the LAN cable when it is coiled or bundled.
™
Inserting or removing the LAN cable during projection may cause
™
noise.
Connectivity with all HDBaseT transmitters on the market is not
™
guaranteed.
Some HDBaseT transmitters may not enable correct projection
™
when used to connect source equipment to the projector.
Commands cannot be received through HDBaseT when the
™
projector is in standby mode.
YPbPr RJ45 HDMI
Lan
IR TX
RS232 RJ45
HD Connect
IR RX
33