4-3: Motor Module; 44: Transformer Module; 4-5: Film Shoe And Bracket Assy., Lens Holder Assy., And Film Gate Assy - Eiki ESL SERIES Service Manual

4-3 MOTOR MODULE
1. Remove motor belt.
2. Disconnect motor nylon connector.
3. Unscrew 3 mounting screws.
4. Remove motor module.
5. To re-install reverse the above
procedures.
Don't forget to reset the
nylon connector(s).
4-4 TRANSFORMER MODULE
1. Remove the three mounting screws.
2. Unplug nylon connectors.
3. To re-install reverse the above procedures.
(Care should be taken that the wires
are routed away from any moving
parts of the projector)
Fig. #10
Fig. #11
4-5 Fl LM SHOE AND BRACKET ASSY., LENS HOLDER ASSY., Fl LM GATE ASSY.
(A) Film Shoe and Bracket Assy.
1. Set function rotary switch at "STOP" position.
2. Remove the lens holder cover plate assembly.
3. Pull from the top of the film shoe bracket.
4. To re-insert the film shoe and bracket assy.,
slide the pin into the lower slot of the recep-
tion bracket and swing the film shoe and
bracket assy. into the upper slot until the plate
spring latches it in place.
Fig. #12
- 26 -