Adjustments - Eiki ESL SERIES Service Manual

B. Adjustments
1. Position of the Lower Loop Setter Roller:
With the function switch in the "Stop" position, the loop setter roller must lock into
the position as in Fig.# 55.
Fig. #55
To check for the correct
positron
of the loop setter roller, set the function switch at
"STOP". The distance between the outer edge of the roller and the main frame casting
should measure 5.5mm. In this position, the film should clear the aperture plate, the film
shoe, and sound drum when rewinding. To adjust the roller position, set the function
switch to "STOP". Loosen the set screw on the loop setter interlocking arm, position the
loop setter roller 5.5mm up from the main frame casting as Fig. #55. Then tighten the set
screw. To obtain the correct position of the loop setter roller tool No. 185-01111 (Fig.
# 56) may be used.
(1) Set the function switch at "STOP".
(2) Apply the tool No. 185-01111 as Fig. #57. Push the roller against the tool.
(3) Loosen the interlocking arm set screw.
(4) Adjust the position of the interlocking arm and secure the set screw.
- 53 -