Remaining Connection Status - GE F60 Instruction Manual

6.2 STATUS
The number of detected incipient faults for each incipient fault element are displayed here for each phase. These values
can be reset to zero with the
PATH: ACTUAL VALUES
 COMM STATUS
 REMAINING CONNECT
These values specify the remaining number of TCP connections still available for each protocol. Every time a connection is
used, the remaining number of connections decrements. When released, the remaining number of connections increments.
If no connection is made over the specific protocol, the number equals the maximum number available for the specific pro-
tocol.
For example, the maximum number of Modbus TCP connections is 4. Once an EnerVista session is opened on a computer
connected to the UR over Ethernet, the Modbus TCP status shows 3. If the EnerVista application is closed, the Modbus
TCP status shows 4.
Note that the maximum number of PMU TCP connections matches the number of aggregators.
6
The Parallel Redundancy Protocol (PRP) defines a redundancy protocol for high availability in substation automation net-
works.
PATH: ACTUAL VALUES
 PRP

TOTAL RECEIVED PORT A
TOTAL RECEIVED PORT B
is a counter for total messages received with an error (bad port code, frame length too short).
TOTAL ERRORS
is a counter for total messages received with an error on Port A (PRP frame, but port received through
MISMATCHES PORT A
and LAN ID in the frame do not match).
is a counter for total messages received with an error on Port B (PRP frame, but port received through
MISMATCHES PORT B
and LAN ID in the frame do not match).
6-12

COMMANDS CLEAR RECORDS
 
STATUS COMM STATUS REMAINING CONNECT
MMS (max 5)
5
MODBUS TCP (max 4)
MESSAGE
4
DNP (max 2)
MESSAGE
2
IEC-104 (max 2)
MESSAGE
2
PMU TCP (max 4)
MESSAGE
4
 
STATUS PRP
Total Rx Port A:
Total Rx Port B:
MESSAGE
Total Errors:
MESSAGE
Mismatches Port A:
MESSAGE
Mismatches Port B:
MESSAGE
is a counter for total messages received (either from DANPs or from SANs) on Port A.
is a counter for total messages received (either from DANPs or from SANs) on Port B.
F60 Feeder Protection System

CLEAR INCIPENT FAULT COUNTERS

6.2.22 REMAINING CONNECTION STATUS

Range: 0 to 5
Range: 0 to 4
Range: 0 to 2
Range: 0 to 2
Range: 0 to 4
6.2.23 PARALLEL REDUNDANCY PROTOCOL (PRP)
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
Range: 0 to 4G, blank if PRP disabled
6 ACTUAL VALUES
command.
GE Multilin