Ordering - GE F60 Instruction Manual

2.1 INTRODUCTION
a) OVERVIEW
The F60 is available as a 19-inch rack horizontal mount or reduced-size (¾) vertical unit and consists of the following mod-
ules: power supply, CPU, CT/VT, digital input and output, transducer input and output, and inter-relay communications.
Each of these modules can be supplied in a number of configurations specified at the time of ordering. The information
required to completely specify the relay is provided in the following tables (see chapter 3 for full details of relay modules).
2
Order codes are subject to change without notice. See the ordering page at
http://www.gedigitalenergy.com/multilin/order.htm
NOTE
The order code structure is dependent on the mounting option (horizontal or vertical) and the type of CT/VT modules
(enhanced diagnostic CT/VT modules or HardFiber
following sub-sections.
b) ORDER CODES WITH ENHANCED CT/VT MODULES
The order codes for the horizontal mount units are shown below.
Table 2–4: F60 ORDER CODES (HORIZONTAL UNITS)
F60 - * ** - *
BASE UNIT F60 | |
CPU T |
U |
V |
SOFTWARE 00
01
03
04
06
07
A0
A1
A3
A4
A6
A7
B0
B1
B3
B4
B6
B7
D0
C0
C1
C3
C4
C6
C7
D1
D3
D4
D6
D7
E0
E1
E3
E4
E6
E7
F0
F1
F3
F4
F6
F7
G0
G1
G3
G4
G6
G7
MOUNT/COATING
FACEPLATE/ DISPLAY
POWER SUPPLY
(redundant supply must
be same type as main supply)
ENHANCED DIAGNOSTICS CT/VT DSP
(8L, 8M, 8N, 8R require DSP to be enhanced diagnostic)
2-8
TM
* * - F ** - H ** - M ** - P
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
| | | | | |
H | | | | |
A | | | | |
C | | | |
D | | | |
R | | | |
A | | | |
P | | | |
G | | | |
S | | | |
B | | | |
K | | | |
M | | | |
Q | | | |
U | | | |
L | | | |
N | | | |
T | | | |
V | | | |
W | | | |
Y | | | |
H | | |
H | | |
L | | |
L | | |
| | XX
8L | 8L
8M | 8M
8N | 8N
8R | 8R
| | 8Z
F60 Feeder Protection System
for the latest options.
process bus modules). The order code options are described in the
** - U ** - W/X ** Full Size Horizontal Mount
| | | Base Unit
| | | RS485 and Three Multi-mode fiber 100Base-FX (SFP with LC)
| | | RS485 and Two Multi-mode fiber 100Base-FX (SFP with LC), One 10/100Base-T (SFP with RJ45)
| | | RS485 and Three 10/100Base-T (SFP with RJ45)
| | | No Software Options
| | | Ethernet Global Data (EGD)
| | | IEC 61850
| | | Ethernet Global Data (EGD) and IEC 61850
| | | Phasor measurement unit (PMU)
| | | Phasor measurement unit (PMU) and IEC 61850
| | | CyberSentry Lvl 1
| | | CyberSentry Lvl 1 and Ethernet Global Data (EGD)
| | | CyberSentry Lvl 1 and IEC 61850
| | | CyberSentry Lvl 1 and IEC 61850 and Ethernet Global Data (EGD)
| | | CyberSentry Lvl 1 and phasor measurment unit (PMU)
| | | CyberSentry Lvl 1 and IEC 61850 and phasor measurement unit (PMU)
| | | IEEE 1588
| | | IEEE 1588 and Ethernet Global Data (EGD)
| | | IEEE 1588 and IEC 61850
| | | IEEE 1588 and IEC 61850 and Ethernet Global Data (EGD)
| | | IEEE 1588 and phasor measurement unit (PMU)
| | | IEEE 1588 and IEC 61850 and phasor measurement unit (PMU)
| | | IEEE 1588 and CyberSentry Lvl 1
| | | Parallel Redundancy Protocol (PRP)
| | | PRP and Ethernet Global Data
| | | PRP and IEC 61850
| | | PRP, Ethernet Global Data, and IEC 61850
| | | PRP and PMU
| | | PRP, IEC 61850, and PMU
| | | IEEE 1588 and CyberSentry Lvl 1 and Ethernet Global Data (EGD)
| | | IEEE 1588 and CyberSentry Lvl 1 and IEC 61850
| | | IEEE 1588 and CyberSentry Lvl 1 and IEC 61850 and Ethernet Global Data (EGD)
| | | IEEE 1588 and CyberSentry Lvl 1 and phasor measurement unit (PMU)
| | | IEEE 1588 and CyberSentry Lvl 1 and IEC 61850 and phasor measurement unit (PMU)
| | | IEEE 1588 and PRP
| | | IEEE 1588, PRP, and Ethernet Global Dada
| | | IEEE 1588, PRP, and IEC 61850
| | | IEEE 1588, PRP, Ethernet Global Data, and IEC 61850
| | | IEEE 1588, PRP, and PMU
| | | IEEE 1588, PRP, IEC 61850, and PMU
| | | PRP and CyberSentry Lvl1
| | | PRP, CyberSentry Lvl1, and Ethernet Global Data
| | | PRP, CyberSentry Lvl 1, and IEC 61850
| | | PRP, CyberSentry Lvl 1, Ethernet Global Data, and IEC 61850
| | | PRP, CyberSentry Lvl 1, and PMU
| | | PRP, CyberSentry Lvl 1, IEC 61850, and PMU
| | | IEEE 1588, PRP, and CyberSentry Lvl 1
| | | IEEE 1588, PRP, CyberSentry Lvl 1, Ethernet Global Data
| | | IEEE 1588, PRP, CyberSentry Lvl 1, and IEC 61850
| | | IEEE 1588, PRP, CyberSentry Lvl 1, Ethernet Global Data, and IEC 61850
| | | IEEE 1588, PRP, CyberSentry Lvl 1, and PMU
| | | IEEE 1588, PRP, CyberSentry Lvl 1, IEC 61850, and PMU
| | | Horizontal (19" rack) - Standard
| | | Horizontal (19" rack) - With harsh environmental coating
| | | English display
| | | French display
| | | Russian display
| | | Chinese display
| | | English display with 4 small and 12 large programmable pushbuttons
| | | French display with 4 small and 12 large programmable pushbuttons
| | | Russian display with 4 small and 12 large programmable pushbuttons
| | | Chinese display with 4 small and 12 large programmable pushbuttons
| | | Enhanced front panel with English display
| | | Enhanced front panel with French display
| | | Enhanced front panel with Russian display
| | | Enhanced front panel with Chinese display
| | | Enhanced front panel with English display and user-programmable pushbuttons
| | | Enhanced front panel with French display and user-programmable pushbuttons
| | | Enhanced front panel with Russian display and user-programmable pushbuttons
| | | Enhanced front panel with Chinese display and user-programmable pushbuttons
| | | Enhanced front panel with Turkish display
| | | Enhanced front panel with Turkish display and user-programmable pushbuttons
| | | 125 / 250 V AC/DC power supply
| | RH 125 / 250 V AC/DC with redundant 125 / 250 V AC/DC power supply
| | | 24 to 48 V (DC only) power supply
| | RL 24 to 48 V (DC only) with redundant 24 to 48 V DC power supply
| XX | No DSP module (slots M and U only)
| | | Standard 4CT/4VT with enhanced diagnostics
| | | Sensitive Ground 4CT/4VT with enhanced diagnostics
| | | Standard 8CT with enhanced diagnostics
| | | Sensitive Ground 8CT with enhanced diagnostics
| | | Hi-Z 4CT (required for high-impedance fault detection element)
2 PRODUCT DESCRIPTION

2.1.3 ORDERING

GE Multilin