GE F60 Instruction Manual page 161

5 SETTINGS
d) NETWORK
As outlined in the previous section, when using more than one Ethernet port, configure each to belong to a different net-
work or subnet using the IP addresses and mask. Configure the network IP and subnet settings before configuring the rout-
ing settings.

PATH: SETTINGS PRODUCT SETUP
 NETWORK PORT 1

MESSAGE
MESSAGE
 NETWORK PORT 2

MESSAGE
MESSAGE
MESSAGE
MESSAGE
 NETWORK PORT 3

MESSAGE
MESSAGE
The IP addresses are used with the DNP, Modbus/TCP, IEC 61580, IEC 60870-5-104, TFTP, HTTP, and PRP protocols.
The next section explains PRP.
Do not set more than one protocol to the same TCP/UDP port number, as this results in unreliable operation of
those protocols.
NOTE
: This setting sets the ports IPv4 address in standard IPV4 format. This setting is valid on port 3 if
PRT1 (2 OR 3) IP ADDRESS
port 2 is set to None.
REDUNDANCY
: This setting sets the ports IPv4 subnet mask in standard IPV4 format. This setting is valid on
PRT1 (2 OR 3) SUBNET MASK
port 3 if port 2 is set to None.
REDUNDANCY
is available when the hardware has multiple ports (modules T, U, and V). It determines if ports 2 and 3
PRT2 REDUNDANCY
operate in redundant or independent mode. If a license for PRP was purchased, the options are None, Failover, and PRP.
If a license for PRP was not purchased, the available options are None and Failover. In non-redundant mode (
set to None), ports 2 and 3 operate independently with their own MAC, IP, and mask addresses. If
Failover, the operation of ports 2 and 3 is as follows:
• Ports 2 and 3 use the port 2 MAC address, IP address, and mask
• The configuration fields for IP address and mask on port 3 are hidden
GE Multilin
 
COMMUNICATIONS NETWORK 1(3)
PRT1 IP ADDRESS:
127.0.0.1
PRT1 SUBNET IP MASK:
255.0.0.0
PRT1 GOOSE ENABLED:
Enabled
PRT2 IP ADDRESS:
127.0.0.1
PRT2 SUBNET IP MASK:
255.0.0.0
PRT2 REDUNDANCY:
None
PRT2 PRP MCST ADDR:
01-15-4E-00-01-00
PRT2 GOOSE ENABLED:
Enabled
PRT3 IP ADDRESS:
127.0.0.1
PRT3 SUBNET IP MASK:
255.0.0.0
PRT3 GOOSE ENABLED:
Enabled
F60 Feeder Protection System
5.2 PRODUCT SETUP
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Enabled, Disabled
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: None, Failover, PRP
None, Failover (if no PRP license)
Range: 01-15-4E-00-01-00 to 01-15-4E-00-01-FF
Range: Enabled, Disabled
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Enabled, Disabled
REDUNDANCY
5
REDUNDANCY
is set to
5-29