Table of Contents
Advertisement
For example: In VFO mode, enter a frequency as
450MHz, set value of beat frequency 5MHz in RPT
SET, ifRPT Type is + RPT, then receiving frequency
is 450MHz, and transmitting frequency is 455MHz; if
RPT Type is -RPT, then receiving frequency is
450MHz, and transmitting frequency is 445MHz; if
RPT Type is SING, receiving
frequency and
transmitting frequency both are 450MHz.
Note: Beat frequency setting is only available in VFO mode
setting; in MR mode, beat frequency can only set through
program software by write the receiving
and transmitting
frequencies directly.
Save Battery (Saveflat)
Set by Menu 36 to enable (ON) or disable (OFF)
battery saving mode. Default: ON.
Scan (SCAN)
Enable scanning feature can monitor desired channel
frequency without manual operation. In familiar with
the use of
scanning,
flexibility of obtained monitor
will increase efficiency.
Scan Mode: Before using scan function, you should
choose which scan mode to scan first through Menu
38. There are two modes optional:
31
~
Time operating scan mode (TO): Scanning stops
when a signal scanned, the radio keep receiving
to the channel about 5 seconds, then it skip the
channel, the scanning continues even if signal is
still
present.
~
Carrier operating scan mode (CO): Scanning
stops when a signal scanned, the radio keeps
receiving to the channel until signal disappears,
then scanning continues. There are 2 seconds
delayed between signal disappears and scanning
continues, so that the transfer station has time to
transfer.
Default mode: TO
Note: Press any key except UP or DOWN key or
press
"CHA+/CHA-NOL+NOL-",
the radio stops
scanning.
Scan range: Users can choose two scanning range:
~
VFO frequency scan: All frequencies on the band
would be scanned.
In VFO
mode,
enter Menu 37 and press M key to
start scanning, the radio automatically scan from
current frequency to higher frequencies in wide
band.
To scan direction toward low frequencies,
press DOWN key or press "CHA-NOL-"
counterclockwise, then scan direction reversed.
To re-scan to higher frequencies direction, just
press UP key or press "CHA+NOL+" clockwise.
Press any key except UP or DOWN key or press
32
Hide quick links:
Advertisement
Table of Contents
