Installation; Connect Power; Radiating Of Radio; Install With Bracket - Leixen VV898 User Manual

Hide thumbs Also See for VV898:
Table of Contents

Advertisement

Installation
Connect Power
This radio should be connected to
13.8V
DC power
supply.
It can not be connected directly to AC
outlet.
Connect the radio to stabilized power supply with
supplied power
cable,
DC power cable can not be
replaced with a thin
wire.
Connect DC power cable to DC power supply, red
wire connects
positive,
black wire connects negative.
Then plug the jack of the power cable into DC power
outlet of
car.
Note:
Make sure to turn off DC power supply and
radio before
connect.
DC power supply is
connected to the vehicle
platform,
be sure to
turn off DC power supply and drive
units.
The DC power can only be connected to AC
power
outlet
after
all
connections
are
completed.
Radiating of Radio
Heat radiation of mobile transceiver is a very
important problem. Heat radiation of this radio takes
advantage of the air by using a bracket to
install.
If the
radio installed in an airtight
place,
it will affect the
3
radio cooling. Poor cooling may cause damage to the
radio. Do not place books or other equipment on the
radio, so as not to obstruct the air
flow.
The distance
between the radio and the wall of car maintain a
minimum interval of 10 cm
space.
Install with Bracket
An adjustable angle bracket is supplied with the
radio.
Please fix the bracket on
car,
demount the two screws
beside the radio and lock them again through the hole
of
bracket.
Note: Do not place the transceiver in the range of an
airbag deployment may be involved
Do not place the radio in the front windshield of car,
the heat of sun may cause damage to the radio.
Connect
Accessories
Hand Microphone: Hand microphone connection jack
is located in the top right of the front panel of radio.
Earphone:
Earphone connection jack is located in the
right of the rear panel of
radio.
The internal speaker
will not sound when earphone is
connected.
Antenna:
Antenna connection is in the left of the rear
panel intercom. Antenna system is composed of an
antenna,
feeder and ground network components.
Only careful consideration of the antenna system and
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents