Table of Contents
Advertisement
PTT ID sent by:
1, Set by transmitter starts, ID code is emitted when
press PTT button.
2, Set by transmitter end, ID code is emitted when
release PTT button.
3, Set by both in transmitter starts or end, ID code is
emitted when press and release PTT button.
Default PTT ID is: 123
PTT ID code setting:
The radio set up a PTT ID code memory, user can
store PTT ID code in "the begin of TX" and "the end
of TX" in programming software. This allows you to
transmit PTT ID by press PTT key directly without
having to press PTT ID code.
ROGER (ROGER)
User can set whether send ROGER or not when call is
over. User can switch "ON" and "OFF" through Menu
32 to enable or disable ROGER. The radio would
transmit a "toot toot" tone when a call is over if
ROGER is enable (ON).
29
REVERSE (REVERSE)
User can only enable REVERSE after enable Beat
Frequency (RPT SET/RPT TYPE) through Menu 34,
35. The receive frequency and the transmit frequency
will be switched if Reverse enable. In VFO / MR / CH
mode, press M key rotate to Menu 33, press M key to
enable Reverse, the screen display "R" icon, that
means Reverse have enabled. Operate the same step to
disable Reverse. Default:
disable.
Beat Frequency (RPT SET/RPT TYPE)
A channel set two frequencies is a way to using two
frequencies at the same time.
The receiving and
transmitting frequencies are not the same. It becomes
easy to operate inconsistent uplink and downlink
frequencies by setting RPT frequency.
Setting mode: In VFO mode, press M key enter to
menu 34, press M key again to enter beat frequency
setting menu, enter value by DTMF microphone or
press "CHA+/CHA-NOL+NOL-"
to choose value.
The frequency value increase or decrease by step
when press "CHA+/CHA-NOL+NOL-".
The range
of value: OO.OOO-399.995MHz.
Enter
menu
35
to
set
RPT
Type,
press
"CHA+/CHA-/VOL+NOL-"
to
select
+RPT/-RPT/SING, press M key to confirm and
exit.
30
Hide quick links:
Advertisement
Table of Contents
